openhabforum.de

Code: Alles auswählen

rule "Grundeinstellung Alarmanlage"
        when
                System started
        then
                EG_Stairwell_AlarmIS.postUpdate(OFF)
                Thread::sleep(1000)
                EG_Stairwell_AlarmES.postUpdate(OFF)

                end

rule     "Alarmanlage Taster zurücksetzen"
when  
      Item  EG_Stairwell_AlarmUS received update
then
            postUpdate (EG_Stairwell_AlarmIS, OFF)
            Thread::sleep(1000)
            postUpdate (EG_Stairwell_AlarmES, OFF)

end

Code: Alles auswählen

rule "Alles Runterfahren  und absichern zum Gassi gehen"
when 
         Item EG_Stairwell_AlarmES  received command ON
 
then
         sendCommand (DB_Boiler_Zirkoleitung, OFF) 
         Thread::sleep(3000)
         sendCommand (EG_LivingDining_Kamera, ON)
         Thread::sleep(3000)
         Doris_Bad_Temperatur_Soll_Setpoint.postUpdate (18.0)
         Thread::sleep(3000)
         EG_Stairwell_Heating.postUpdate (17.0)
        
end
rule " Alles wieder Rauffahren "
when
         Item EG_Stairwell_AlarmUS  received command OFF
         then   
         sendCommand (DB_Boiler_Zirkoleitung, ON) 
         Thread::sleep(3000)
         sendCommand (EG_LivingDining_Kamera, OFF)
         Thread::sleep(3000)
         Doris_Bad_Temperatur_Soll_Setpoint.postUpdate (22.0)
         Thread::sleep(3000)
         EG_Stairwell_Heating.postUpdate (21.0)
         end

Code: Alles auswählen

rule "control shutter Schalter freigeben"                                                              
when                                                                                 // list of triggers
    Member of gShutter received command                                              // a member of the group received a command
then                                                                                 // what to do
    if(!(receivedCommand instanceof Number))                                         // received command is not a number
        switch receivedCommand {                                                     // decide dependend on received command
            case UP : triggeringItem.sendCommand(OFF)                                  // command is UP, so send 0
            case DOWN : triggeringItem.sendCommand(ON)                              // command  is DOWN, so send 100
            default : logWarn("shutter","Command {} not supported!",receivedCommand) // any other command will cause a warn log
        }                                                                            // end of switch block
    else                                                                             // command is a number
        logInfo("shutter","received Number {}, doing nothing!",receivedCommand)      // log an info that the command was a number
end